top of page
Search
How to Paint Over Wallpaper: A Practical Guide

How to Paint Over Wallpaper: A Practical Guide

Writer: Wix
Wix
Oct 17
6 min read

A room can look dated because of its wallpaper, but stripping it is not always the right first move. If the paper is sound, well bonded and free from serious damage, learning how to paint over wallpaper can be a practical way to refresh the space with less disruption. The finish will only be as good as the preparation beneath it, however. Painting straight over loose seams, bubbles or greasy marks usually makes those problems more visible, not less.

For homeowners, landlords and commercial property managers, the decision comes down to condition, timescale and the standard of finish required. A carefully prepared painted wallpaper surface can look smart and last well. In other cases, removal and repair are the more dependable investment.

Should you paint over wallpaper?

Painting over wallpaper is suitable when it is firmly adhered across the whole wall, reasonably smooth and dry. It can be particularly useful where removal may damage old plaster, where a room needs a prompt refresh, or where the existing paper is acting as a stable lining layer.

It is less suitable for heavily textured papers, woodchip, embossed finishes, loose or lifting wallpaper, and papers with obvious staining or mould. Vinyl and washable wallpapers also need extra care. Their non-porous surface can prevent ordinary paint from bonding properly, so a suitable adhesion primer is essential. Even then, it is worth considering whether removal will give a better long-term result.

Do not paint over active damp, mould or a leak. Paint may hide the symptoms for a short time, but it will not deal with the cause. Resolve the moisture issue, allow the wall to dry thoroughly and repair any affected areas before decorating.

Check the walls before you start

Good preparation starts with a close inspection in daylight. Run your hand over the wall and look along its surface from an angle. This helps reveal raised seams, small bubbles, tears, dents and areas where the paper has started to release.

Pay particular attention to corners, around radiators, behind doors and near windows. These are common areas for wallpaper to lift. Press gently on suspect sections. If the paper moves, feels spongy or sounds hollow, it is not a reliable surface for paint.

If only a small area has lifted, it may be possible to re-adhere it with wallpaper adhesive. Lift the edge carefully, apply a modest amount of adhesive, press it flat and wipe away any excess with a clean damp cloth. Leave it to dry fully before moving on. Large areas of failed paper are usually a sign that the wallpaper should be removed instead.

A test patch is sensible if you are unsure how the paper will react. Prime and paint a discreet section, then allow it to dry. Check for bubbling, staining or poor adhesion before committing to the full room.

How to paint over wallpaper for a smooth finish

Clean without soaking the paper

Dust, cooking residue, hand marks and polish can all interfere with adhesion. Vacuum the wall using a soft brush attachment, then wipe it with a lightly damp microfibre cloth and a mild sugar soap solution where needed. Avoid saturating the wallpaper. Too much water can soften the paste and cause seams to open.

Rinse away cleaner residue with a clean, well-wrung cloth and allow the surface to dry completely. In kitchens, hallways and commercial spaces, this cleaning stage often makes more difference than people expect.

Secure seams and deal with minor damage

Once the wall is clean and dry, glue down any small loose edges. Use a seam roller lightly rather than pressing hard enough to squeeze out adhesive or mark the paper. Small tears, pinholes and shallow dents can be filled with a fine surface filler.

Keep filler confined to the damaged area and feather the edges out. After it has dried, sand it smooth with fine abrasive paper. Take care around seams: aggressive sanding can lift the wallpaper or create a shiny, uneven patch. Professional dustless sanding keeps the room cleaner while helping achieve a more even surface, especially where several repairs are required.

If the seams are raised but sound, a very thin skim of filler along the join can soften their appearance. This takes patience. A thick ridge of filler may look acceptable before painting but can catch the light once the room is finished.

Prime the wallpaper properly

Primer is the stage that protects the final result. It helps paint adhere, seals repairs and reduces the risk of stains showing through. The right product depends on the wallpaper and what is underneath it.

For standard porous wallpaper in good condition, a quality water-based primer or mist coat specified for the surface may be enough. For vinyl, washable or glossy paper, use an adhesion primer designed for difficult, low-porosity surfaces. For nicotine, water marks, strong colours or unknown stains, a stain-blocking primer is the safer option.

Apply one thin, even coat and allow it to dry for the full time stated by the manufacturer. Do not rush this stage. Heavy primer coats can re-wet the wallpaper and encourage bubbling, particularly on older paper.

Apply paint in thin, controlled coats

Choose a durable interior emulsion suited to the room. A washable matt or durable matt finish works well in most living spaces, while kitchens, bathrooms and busy commercial areas may benefit from a more moisture-resistant, scrubbable product. A low-sheen finish is often more forgiving than silk, which can highlight every seam and repair.

Cut in around edges with a good-quality brush, then use a medium-pile roller for broad areas. Load the roller evenly and work in manageable sections, maintaining a wet edge to avoid lap marks. Do not press hard. Excessive pressure can disturb seams or leave roller lines.

Two thin coats usually provide the most consistent coverage. Let the first coat dry fully before applying the second. Dark colours, strong patterns and stain-blocking primers may require an additional coat, but it is better to build coverage gradually than flood the wallpaper with paint.

Common problems and what they mean

Bubbles appearing during priming or painting are a warning sign. Small bubbles sometimes settle as the coating dries, but large bubbles or areas that remain raised usually indicate that the wallpaper has lost its bond. Stop painting, let the wall dry and assess the extent of the problem. Continuing to coat a failing surface will not make it stable.

Visible seams are another common concern. Paint can reduce the contrast between wallpaper strips, but it cannot always make joins disappear. A matt finish, careful filling and a sensible colour choice will minimise their appearance. If a completely seamless, newly plastered look is the goal, removing the paper and preparing the wall is normally the better route.

Stains bleeding through a fresh coat mean the surface has not been sealed sufficiently. Allow the paint to dry, apply a suitable stain blocker to the affected area or wall, then repaint. Adding more ordinary emulsion alone rarely solves the issue.

When removing wallpaper is the better choice

There is no benefit in saving time at the start if the finished wall will soon need attention. Remove the wallpaper when it is loose in several areas, heavily textured, mould affected, damaged beyond local repair or covered with multiple old layers. The same applies if you are planning major repairs, electrical work or a high-specification finish for a sale, refurbishment or customer-facing business space.

Removal can reveal cracks, blown plaster or uneven walls that need repair, so it is not always the quicker option. Yet it gives you a stable surface and more control over the final appearance. For commercial premises, this can be worthwhile where durability, brand presentation and minimal future maintenance matter.

A finish that stands up to everyday life

Painting over wallpaper is not a shortcut when it is done properly. It is a measured decorating decision that relies on sound paper, careful cleaning, the correct primer and patient application. If you are uncertain whether your walls are suitable, an experienced decorator can assess them before work begins and explain the likely finish clearly.

Ellis Painting & Decorating approaches preparation with the same care as the final coats, protecting your space and keeping disruption to a minimum. A little more attention before the roller comes out is what gives a refreshed room the tidy, durable finish it deserves.

 
 
 

Comments


bottom of page